Leather Wall Panel Forming Machine
3D Leather Wall Panel Machine
Forming time: 2 minutes
Pressure: 0.8 MPA
This is the third generation (newest generation) leather wall panel
forming machine . machine cut from a piece of steel as a whole,
stable and solid. Two stations, automatic forming and sealing edge
in two minutes , and no need hot melt paper for sealing edge , save
cost. the production speed is twice the old generation leather wall
panel forming machine.
1, the electrical system adopts programmable controller PLC has
data input and output devices and safety logic control
function,support automatic and manual operation.
2, low-voltage electrical components adopt advanced photoelectric
sensor and thermocouple,can precisely control the key parts
operation and has high stability.
3, the body using high-precision, high-strength steel alloy frame
construction and special welding techniques and materials,
rigidity, abrasion resistance to vibration, long life.
4, use pneumatic pressure and heat molding, short cycle times and
5, vacuum pump and compressor equipped, PLC insure the cylinder
parts runs steady and non impact)
6,air compressor and vacuum pump running at the same
time,thermostat heating system can adapt different environmental
temperatures.Above factors ensure a high degree of consensus on the
molded product accuracy
7, use motor,power,gas integration technology , each program
controlled, safe and reliable, high rate of finished products and
low waster rate.
8,This machine could various designs of leather wall panels with changing the molds.